ARDES ARBOL01 Mode D'emploi page 10

Contact with food
Only these parts are intended for contact with food, under the conditions indicated:
Parts intended for contact
with food
Jug (inner part),
Lid (inner part), Filter
- These parts can only be used with this appliance. Do not use the parts separately for other applications.
First use.
Rinse the kettle with water.
Fill water kettle up to the maximum level and bring the water to a boil.
Empty the kettle and throw the water. Repeat this operation for 3 times.
Operation.
Place the base on a level and stable and connect the plug into the outlet.
Take the kettle. To open the cover, press the appropriate button (if envisaged on the model in your possession).
Filled with water from the kettle through the lid open.
FILL ALWAYS MORE THAN THE MIN LEVEL AND DO NOT FILL ABOVE THE MAX LEVEL.
Close the lid. Check that the lid is properly closed to prevent the water evaporate when it boils.
Make sure that the switch is in position "0" before placing it on the base.
Place the kettle on the base and put the switch on "I".
When the water boils the kettle will turn off automatically.
To stop the operation of the machine put the switch in position "0".
Always make sure that the kettle is switched off (power switch to "0") before removing it from the base.
Note:
This appliance is equipped with a safety device that automatically interrupts the heating in case it inadvertently
switched on when it is empty, with little water or with too many deposits of limestone.
In this case, remove the kettle from the base and allow it to cool completely before filling it again with water. If
necessary, carry out the descaling.
Avoid in any cable to operate the kettle when it is empty or with a little water because this would cause a shorter
duration of the heating element.
Disconnect the plug from the socket and let the appliance cool down well before cleaning it.
To clean, open the appliance and remove food residues from the plates.
For cleaning of the plates, use a sponge or a soft cloth dampened with hot water; do not use steel wool or other
abrasive items which could damage the non-stick coating.
In order to clean the appliance, use a soft or slight damp cloth.
Do not use very wet substances, liquids or cloths to prevent water from entering into the appliance and irreparably
damaging it.
NEVER IMMERSE THE APPLIANCE INTO THE WATER.
Cleaning the filter
The filter serves to prevent the particles of limestone are poured into the cups.
For cleaning, remove the filter from the kettle and wash it under running water with a soft brush.
Descaling.
To prolong the life of the kettle, remove regularly the limestone.
In the case of normal use (up to 5 times per day), we recommend that you remove the limestone and to make
this operation about once a month:
- Pour a solution of water and vinegar (in equal parts) in the kettle, so as to cover the bottom of kettle completely.
- Let the solution for a few hours or the whole night.
- Empty the kettle and rinse it with clean water carefully.
- Fill the kettle with clean water and bring to a boil.
- Empty the kettle and rinse again with clean water.
- Repeat this procedure until the complete removal of the limescale from the kettle and to remove any residual
vinegar.
You can also use specific products for "descaling".
In this case, follow the instructions on the packaging of the product.
Instructions for use
Types of food
water
Maintenance
Maximum temperature
100°C
EN
Maximum time of
contact
30 min
EN
9