This product is manufactured in accordance with the requirements of the
EU Directive 2001/98/EC on General Product Safety, the Consumer Protection Act,
and of the European Standards: EN 716-1:2017+AC:2019; EN 716-2:2017.
IMPORTANT! READ CAREFULLY AND KEEP FOR FUTURE REFERENCE
WARNING!
•
WARNING! Be aware of the risk of open fire and other sources of strong heat such as electric
bar fires, gas fires etc. in the near vicinity of the cot.
•
WARNING! Do not use the cot if any part is broken, torn, or missing. Use only spare parts
approved by the manufacturer.
•
WARNING! Do not leave anything in the cot or place the cot close to another product, which
could provide a foothold or present a danger of suffocation or strangulation, e.g., strings,
blind/curtain cords etc.
•
WARNING! Do not use more than one mattress in the cot.
•
A cot is ready for use when the locking mechanisms are engaged. Check carefully that locking
systems are fully engaged before using the folding cot.
•
All assembly settings should always be tightened properly and should be checked regularly
and retightened if necessary.
•
To prevent injury from falls that when the child is able to climb out of the cot, the cot shall
no longer be used for that child.
•
WARNING! Only use the mattress sold with this cot, do not add a second mattress on this
one, suffocation hazards!
•
Accessories which are not approved by the manufacturer shall not
be used. Never hang additional accessories on the cot except the
musical fretboard which is provided with the cot and described in
the instructions.
•
Assemble, unfold and fold the product ONLY by an adult.
•
Using the product as fixed to the adult's bed is only permitted with beds and/or mattress
with straight sides.
•
ATTENTION! Do not use the "Co-sleeping function" of the crib if the height of the adult's bed
is less than 45 cm or more than 60 cm above the floor.
•
When using the product at "Co-sleeping function", to prevent a suffocation hazard from
entrapment, the bedside sleeper shall be properly secured to the adult bed using the
attachment system.
•
Always use the attachment system provided with this product.
•
Check the tightness of the attachment system before each use by pulling the bedside sleeper
in a direction away from adult bed.
•
If there is any gap between the bedside sleeper and adult bed DO NOT use the product.
•
The maximum distance between the crib and the parent's bed should be 2 cm.
IMPORTANT! The diagrams and figures in this instruction are illustrative and indicative only.
Follow exactly the instructions and sequence for assembling and operating with the product.
Check the securing of the fixation after each operation.
ASSEMBLY AND OPERATING INSTRUCTIONS
EN
20