MTD Yard-Man YMGBV3100 Manuel De L'opérateur page 8

ATTACHING AND REMOVING THE
BLOWER/VACUUM TUBE
WARNING:
blower/vacuum tube and vacuum bag must
be used when operating this unit.
Attaching
NOTE: The blower/vacuum tube comes un assembled
on this unit. Installation is required to provide
safe and easy use for the operator.
WARNING:
the engine and allow the impeller to stop
before attaching or removing tubes.
1. Remove the screws and nuts provided from the
hardware pack.
2. Insert the blower/vacuum tube all the way into the
opening on the motor housing until the holes in the
tabs on the blower/vacuum tube align with the screw
holes in the housing (Fig. 1).
3. Insert the 2 (two) 8-32 x 3/4" slotted T20 Torx screws
into the right side of the motor housing and the 2 (two)
nuts into the left side of the motor housing (Fig. 1).
Screw
Self-Tapping Screw
4. Tighten the screws firmly. Do not over-tighten.
5. Install the 2 (two) remaining self-tapping 8-16 x 3/4"
slotted T20 Torx screws into the holes on either side
of the housing (Fig. 1). Tighten until snug, do not
over-tighten.
8
ASSEMBLY INSTRUCTIONS
To avoid serious
personal injury, the
To prevent serious
personal injury, stop
Motor Housing
Nut
Blower/Vacuum
Tube
Fig. 1
Removing
NOTE: It may be necessary to remove the
blower/vacuum tube to clear a blocked tube or
impeller.
WARNING:
the engine and allow the impeller to stop
before attaching or removing tubes.
1. Remove the 2 (two) self-tapping screws from either
side of the housing.
2. Remove the 2 (two) screws and nuts holding the
blower/vacuum tube on the housing (Fig. 2).
NOTE: Keep the hardware in a safe place for future use.
Screw Self Tapping
and Nut Screw
3. Remove the blower/vacuum tube from the motor
housing.
4. Replace blower/vacuum tube before use.
To prevent serious
personal injury, stop
Screw and Nut
Fig. 2