Tripp-Lite isobar PDUMH15-ISO Manuel Du Propriétaire page 3

Installation
Note: The illustrations may differ somewhat from your PDU model.
1
Determine Installation Configuration.
The PDU supports four primary installation
configurations: 1U Rack, 0U Rack, Wall
and Under-Counter. Choose a
configuration and follow the installation
instructions in the appropriate section of
Step 1 before proceeding to Step 2.
Note: Regardless of installation
configuration, the user must determine
the fitness of hardware and procedures
before mounting. The PDU and included
hardware are designed for common rack
and rack enclosure types and may not be
appropriate for all applications. Exact
mounting configurations may vary.
1-1
1U Rack Installation. Attach the PDU to
the rack by inserting four user-supplied
screws (A) through the PDU mounting
brackets (B) and into the mounting holes
of the rack rail as shown.
1-2
0U Rack Installation. Part 1: Remove
the screws (C) attaching the mounting
brackets to the PDU, change the
orientation of the brackets as shown and
reattach the brackets. Use only the screws
supplied by the manufacturer or their
exact equivalent (#6-32, 1/4" flat head).
Part 2: Attach the PDU vertically by
inserting two or more user-supplied screws
(A) through the PDU mounting brackets
(B) and into mounting points in the rack
or rack enclosure.
1-3
Wall Installation. After repeating Part 1
above, attach the PDU to a stable
mounting surface by inserting two or more
user-supplied screws (A) through the PDU
mounting brackets (B) and into secure
mounting points on the mounting surface.
1-4
Under-Counter Installation. After
repeating Part 1 above, attach the PDU to
a stable mounting surface by inserting four
user-supplied screws (A) through the PDU
mounting brackets (B) and into secure
mounting points on the mounting surface.
14-08-270-9333B9.indb 3
B
1-1
B
1-2
B
1-3
C
1-4
3
A
C
A
C
A
B
A
9/15/2014 4:09:42 PM