Publicité
Les langues disponibles
Les langues disponibles
7.1 Floor-mounted unit
Set up heater fan in a vertical position.
Ensure that unit is level and stable.
7.2 Wall assembly
Risk of injury and burns if
the unit is incorrectly wall
mounted.
DANGER
Only mount the unit on a wall
with adequate load-bearing
capacity and characteristics.
Note the weight of the unit.
The appropriate mounting
material must be supplied by
the customer.
Prescribed minimum distances
Use the wall bracket [3] supplied to mount
the unit.
Make sure there is a flat surface to mount
the wall bracket on.
Attach the wall bracket to the wall with
suitable fixing material ("S1", not included).
Suspend the unit from the centre of the wall
bracket as shown in the diagram below
using the tubular stand.
Make sure the unit is level. The control
panel must be easily accessible.
Screw locking bolt "S2" fully into the wall
bracket to ensure that the unit is securely
bolted to the wall.
7.3 Electrical connection
● The connecting cable for 400 V units is to
be supplied by the customer.
● Fuse protection with 3-way circuit-breaker
is required for 400 V units:
– MHD 5 and MHD 9 with 16 A for each
phase
– MHD 15 and MHD 20 with 32 A for each
phase
For the sake of security operate the unit
with a residual current device RCD (max.
30 mA).
.
11
Publicité
