Publicité
Les langues disponibles
Les langues disponibles
Ensure that the lid is firmly in place before connecting the power cord
to the outlet.
2.
Close the lid. Position the kettle on the power base in place. Make sure
the kettle contact with the power base completely.
Connect the plug into a power outlet. Press down the switch to "I"
3.
position and the switch light illuminates. Then start to boil the water.
The kettle will switch off automatically once the water has boiled and
eg the switch light extinguishes. You can shut off the power by
pressing the switch at any moment during boiling
that switch is clear of obstructions and the lid is firmly closed.
kettle will not turn off if the switch is constrained or if the lid is left open.
4.
Lift the kettle from the power base and then pour the water.NOTE:
Operate carefully when pouring the water from your kettle as boiling
water may result in scald, besides, don't open the lid while the water in
the kettle is hot.
5.
The kettle will not re-boil until the switch is uplifted. Allow to cool for
15~20 seconds before reopening to boil water. The kettle may be
stored on the power base when not in use.NOTE：Ensure power
supply is turned off when kettle is not in
6.
If the supply cord is damaged, it must be replaced by the
manufacturer, its service agent or similarly qualified persons in order
to avoid a hazard.
7.
CAUTION: Insure that the appliance is switched off before removing
it from its stand.
Boil-dry protection
Should you accidentally allow the kettle to operate without water, the boil-
dry protection will automatically switch it off. If this should occur, allow the
kettle to cool before filling with cold water and re-boiling.
CARE AND CLEANING
Always disconnect the appliance from the power outlet and leave it to cool
down completely before cleaning.
use.
37
water.NOTE：Ensure
The
Publicité
