Cuda surgical LLS-3736-2 Manuel De L'opérateur page 4

3. TECHNICAL SPECIFICATIONS
Input
Output
Operating Temperature
Storage Temperature
Operating Humidity
Storage Humidity
Dimension (without battery adaptor)
Weight (without battery adaptor)
Regulatory Approvals
Water Resistant
4. BATTERY CHARGING INSTRUCTIONS
Place the charger on a stable surface. Plug the output connector of the external AC/DC
power supply into the DC input located on the rear of the charging station. Then plug
the external AC/DC power supply into an AC outlet.
The charge process will start after inserting a battery pack into the slot. The charge
indication will be displayed (see Table 1).
LED Indicator
None
Green on (4)
Green on (1)
Orange on (2)
Blinking Orange on (2)
Red on (3)
Blinking Red (3)
LIT 232
®
CUDA Surgical
(English)
Item
Figure 1. Indication Display
Off-Mode / Battery is not installed
Charger is being supplied power
Charging is completed
Charging in process
Standby mode (due to abnormal temperature)
Abnormal charge mode (due to defective battery pack)
Defective charger mode
Table 1. LED Indicator Legend
Refer to Figure 1 for Display Map
Specification
24V 2.5A max
16.8V 3.3A max
41⁰F to 95⁰F (5⁰C to 35⁰C)
14⁰F to 140⁰F (-10⁰C to 60⁰C)
10% to 90%
5% to 95%
(LxWxH) 8.9in x 3.7in x 6.1in
1.35lbs
UL listed and CE
Not Protected Equipment, IPX0
Charging Condition
Date of Revision:01/26/18
Rev. -
Page 4 of 31