CaterMarket FPP-36 Notice D'installation Et D'emploi page 8

8
. To only heat up the oven, press PRH
. To set the temperature, press P..
. To stop baking prior to the end of the program, press STOP. The unit will switch into
Standy Mode. The temperature will display on the control panel.
. If one of the three programs is selected, the oven willheat u pand the (red) control light for
the selected program will fl ash.
. The remaining time for the selected program will count down (option T1-T3), with the time
Remaining displayed on the control panel next to the indicator „TIME"
In the event the time is over 9 minutes and 59 seconds, the time will count down in unit of 10
seconds.
. Every 12 seconds the temperature will be displayed for two seconds.
.. When the selected temperatur eis reached (/optons L1-L3), the green control light will come
on
. The end of a cycle is indicated by a tuice-repeating audible signal, and the control lamp will
fl ash green and red.
. The signal can be stopped by pressing STOP
. The initial baking time can be extended or shortened dutiny the cycle.
The fourth program may be activated by pressing TIME
The selected time will be displayed, which can be extended by pressing PIZZA A or
Shortened by pressing STOP. Confi rm by pressing START or °C.
. When the temperatur eis displayed on the control panel, it can be adjusted up or down usány
the arrows on the panel. Confi rm the temperature setting by pressing START.
. After twice pressing START the selected program will begin functionning.
. Beginning values may b ethose set at the end, in which cace the red control light dones on.
. Two cycles may be combined by simultaneously pressing TIME and °C.
. If the control light fl ashes orange, the oven is functioning according to previously-set values.