Publicité
Les langues disponibles
Les langues disponibles
OPERATING INSTRUCTIONS
ASSEMBLY AND INSTALLATION
Check that the air conditioner is tilted downwards to the outside, about
3° to 4°, as shown in Fig. 7. After proper installation, condensed water
should not drain from the overfl ow drain hole during normal use. If you
notice water leaking out, check the angle of tilt, and make any neces-
sary adjustments. However, on a very humid day, water leakage can
occur – this is normal.
Measure the tilt angle from the cabinet's edge. The distance H should
be approximately 5/8" to 3/4".
CONTROLS
FAN SPEEDS:
•
LOW FAN
will circulate air at minimum speed without cooling.
•
HIGH FAN
will circulate air at maximum speed without cooling.
SELECTOR SWITCH: The selector switch controls cooling mode. Simply rotate the SELECTOR knob to one of the two
settings described below.
COOLING MODES:
•
LOW COOL
•
HIGH COOL
hot days. Once room is cooled, reduce setting to LOW COOL.
•
OFF shuts the unit down completely.
NOTE: Always allow 3 minutes before switching from one mode to another.
THERMOSTAT: The thermostat automatically controls the (compressor) cooling cycle and maintains the selected room
temperature. To set the thermostat, rotate the thermostat knob to the desired cooling setting (1 warmest - 7 coldest).
Turn the selector switch slowly, allowing the unit to adjust.
When using THERMOSTAT, be sure to allow three minutes
before changing the temperature. Adjusting too quickly may
cause compressor to overload.
provides cooling with minimum air circulation. Recommended for night-time use.
provides cooling with maximum air circulation. Recommended for quick cooling or for extremely
IMPORTANT
Fig. 7
7
Measure the tilt angle from the cabinet's edge
: approximately
5/8" to 3/4"
WINDOW
Thermostat
Selector
Switch
OFF
arrêt
Publicité
