Publicité
5) CLEANING AND MAINTENANCE OPERATIONS
5.1 GENERALITIES AND PRODUCTS FOR CLEANING
BEFORE CARRYING OUT ANY CLEANING OR MAINTENANCE OPERATIONS, CHECK TO MAKE SURE
THAT THE MAINS SWITCH BE OFF AND THE SUPPLY PLUG DISCONNECTED FROM THE MAINS.
ACCURATELY CLEAN THE EQUIPMENT EVERY DAY FOR A CORRECT OPERATION AND LIFE OF
THE EQUIPMENT.
DESPITE THE SEVERAL SAFETIES, TAKE GREAT CARE TO AVOID CUTTING RISKS WHEN USING
THE BLADE.
CLEAN THE EQUIPMENT WITH THE USUAL NEUTRAL DETERGENTS WHICH MUST NOT CONTAIN
SODA OR ALCOOL. WHEN CLEANING REMOVED ELEMENTS, DO NOT USE A DISH-WASHER FOR
NOT DAMAGING ANODIZED PARTS.
5.2 REMOVAL OF THE FOOD SADDLE (FOR GPR 300 SG ONLY)
1. SET THE NUMBERED KNOB "A" ON "0" POSITION TO CLOSE SLICE THICKNESS ADJUSTMENT.
2. TURN OFF THE KNOB "B".
3. MOVE THE CARRIAGE NEAR THE NUMBERED KNOB AS INDICATED FIG. 8-9 UP TO THE CLOSE.
4. REMOVE THE COMPLETE CARRIAGE WITH SUPPORT AS INDICATED IN FIG. 9.
TO REPLACE THE CARRIAGE FOLLOW THE POINT 4 OPPOSITE AND TURN ON THE HANDLE "B" .
THE CARRIAGE CAN BE WASHED UNDER WATER.
ATTENTION!!!! DO NOT REMOVE THE CARRIAGE IF THE BLOCK DEVICE IS NOT ON. WITHOUT THIS
DEVICE THE CARRIAGE CAN NOT BE REMOVED. WHEN THE BLOCK IS ON DO NOT MOVE THE
CARRIAGE OR TURN THE HANDLE.
5.3 REMOVAL OF THE BLADE-COVER
1. LOOSEN THE KNOB OPPOSITE TO THE BLADE (Fig. 10)
2. PUSH THE KNOB TOWARDS THE BLADE AND RELEASE THE BLADE COVER FROM ITS HOUSING.
3. REMOVE THE BLADE-COVER FROM THE SLICER AND CLEAN IT WITH A WATER JET. (Fig. 11)
5.4 CLEANING THE BLADE AND RING
CLEANING THE BLADE AND RING IS A DANGEROUS OPERATION, HENCE, TAKE GREAT CARE TO
PREVENT ANY POSSIBILITY OF CUTTING.
FOR THEIR CLEANING NEVER USE A WATER JET, BUT USE A DAMP CLOTH AND DETERGENTS,
THEN RINSE AND DRY WITH A CLOTH.
FOR THE CLEANING, USE NON-TOXIC PRODUCTS WHICH GUARANTEE THE PERFECT HYGIENE.
CLEAN CAREFULLY THE BLADE EDGE AND THE INSIDE OF THE RING.
1. USE A DAMP CLOTH TO CLEAN THE OPENING BETWEEN THE BLADE AND RING. (Fig.12)
2. ROTATE MANUALLY THE BLADE AND CLEAN USING THE DAMP CLOTH.
5.5 REMOVING AND CLEANING THE SHARPENER HEAD
LOOSEN THE KNOB AS SHOWN IN FIGURE, LIFT THE HEAD AND THE SHARPENER UNIT, AND
REVOVE THESE UNITS BY LIFTING. (Fig. 13-14)
5.6 REASSEMBLING THE MACHINE
FOR THE MACHINE REASSEMBLY, REVERSE ALL THE ABOVE MENTIONED OPERATIONS.
13
Publicité
