Publicité
3.2 ELECTRIC CONNECTIONS
THE EQUIPMENT IS SUPPLIED WITH AN ELECTRIC CABLE TO BE CONNECTED TO A MAGNETO-
THERMIC MAIN SWITCH WHICH STOPS THE MACHINE WHEN THE OPERATOR COMES IN
FORTUITOUS CONTACT WITH THE ROTATING ELEMENTS.
IT IS IMPERATIVE THAT THE EQUIPMENT IS WELL GROUNDED ACCORDING TO THE REGULATIONS
IN FORCE
THE MANUFACTURER DECLINES ANY AND ALL RESPONSIBILITY FOR DIRECT AND INDIRECT
DAMAGES WHICH MAY ENSUE FOR NON-COMPLIANCE WITH THE REGULATIONS IN FORCE.
ALL THE SLICERS OF THE SERIES "GRAVITY GPR" ARE MANUFACTURED INTO TWO VERSIONS:
THREE-PHASE V.400/3/50 HZ, OR SINGLE-PHASE V.230/1/50 HZ.
WHENEVER THE VOLTAGE DIFFERS FRON THE ABOVE MENTIONED ONES, PLEASE APPLY TO THE
MANUFACTURER, OR THE AUTHORIZED DISTRIBUTOR. (See figures 1 and 2).
WARNING
BEFORE CONNECTING THE EQUIPMENT TO THE THREE-PHASED MAINS, CHECK
THE DIRECTION OF ROTATION OF THE BLADE.TO STOP THE EQUIPMENT, PRESS ONCE THE
START GREEN BUTTON AND THEN THE STOP RED BUTTON.
LOOKING AT THE MACHINE FROM THE SIDE OF THE BLADE-COVER, THE BLADE DIRECTION OF
ROTATION MUST BE CLOCKWISE. SHOULD NOT THE DIRECTION OF ROTATION BE CORRECT,
REVERSE TWO OF THE THREE SUPPLY WIRES (INSIDE THE PLUG OR SOCKET). Fig. 3
3.3 SAFETY MEASURES AND TRAINING THE FINAL USER
THE SKILLED PERSONNEL IN CHARGE OF THE INSTALLATION AND ELECTRIC CONNECTIONS IS
RESPONSIBLE OF THE TRAINING OF THE FINAL USER, WHICH MUST ALSO BE INFORMED ON THE
SAFETY MEASURES TO COMPLY WITH.
THIS INSTRUCTION MANUAL COMES WITH EACH EQUIPMENT.
4.1 CONTROLS FOR GPR SLICERS
THE CONTROLS AND PILOT LIGHT ARE SET ON THE RIGHT SIDE OF
MACHINE IS PLACED IN FRONT OF THE OPERATOR. (Fig. 4)
1-BUTTON FOR STARTING THE EQUIPMENT ( I )
2-BUTTON FOR STOPPING THE EQUIPMENT ( O )
3-WHITE PILOT LIGHT BETWEEN THE TWO BUTTONS
4.2 CONTROLS FOR FAP SLICERS
THE CONTROLS AND PILOT LIGHT ARE SET ON THE RIGHT SIDE OF
MACHINE IS PLACED IN FRONT OF THE OPERATOR. (Fig. 5)
1-GREEN BUTTON FOR STARTING THE EQUIPMENT
2-RED BUTTON FOR STOPPING THE EQUIPMENT
4.3 SETTING THE FOOD ON THE SLICER SADDLE
1. SET THE FOOD ON THE SADDLE WHEN THE THICKNESS ADJUSTING KNOBIS SET TO ZERO AND
WITH MOTOR OFF TO AVOID DAMAGING THE EQUIPMENT.
2. SET THE FOOD ON THE SADDLE AND BLOCK IT WITH THE FOOD-PRESS. (Fig.6)
3. SET A HAND ON THE FOOD-PRESS AND START THE CUTTING.
4. WHEN THE FOOD IS FULLY SLICED USE THE FRONT PART OF THE FOOD-PRESS TO KEEP THE
FOOD AGAINST THE BLADE. (Fig. 7)
5. WHEN THE CUTTING IS OVER, PUT OFF THE MOTOR AND STOP THE SLICE THICKNESS ON
ZERO POSITION, THEN REMOVE THE FOOD FROM THE SADDLE.
4) USE OF THE EQUIPMENT
THE BASE WHEN THE
4-KNOB FOR ADJUSTING SLICE THICKNESS
5-SADDLE RELEASE ONLY FOR GPR 300SG
6-LUBRICATOR
THE BASE WHEN THE
3-KNOB FOR ADJUSTING SLICE THICKNESS
4-LUBRICATOR
12
Publicité
