Eiko LED T8 Linear tube Instructions D'installation

INSTALLATION INSTRUCTIONS
LED T8 Linear tube
IMPORTANT
• Before installing lamp, read all instructions and retain for future reference. The important instructions and
safeguards that appear in this document are not inclusive of all possible conditions and situations that may
occur. It must be understood that common sense, caution, and care are factors that cannot be built into a
product. These factors must be supplied by those that care and operate the fixture.
• For additional information required and not covered in this document please contact a local representative.
Safety Precautions
• Risk of electric shock or fire!
• Do not expose directly to water or submerge lamp.
• For use in dry or damp locations only.
• Ensure power is OFF at the electrical panel before starting installation or maintenance.
• Verify site supply and voltage matches to the product being installed.
• Ensure wiring connections are not exposed during operation.
• Modifications to the product will void warranty.
• Only use in place of fluorescent lamps.
• Do not place any objects on the lamp.
• Do not install in a pre-heat luminaire.
• This lamp only operates on electronic ballasts.
• Perform a visual inspection to ensure lampholders are not damaged, corroded, blackened, or loose, contact a
qualified electrician for proper replacement.
• This device complies with part 18 of the FCC rules.
• This product may cause interference to radio equipment and should not be installed near maritime safety
communications equipment or other critical navigation or communication equipment operating between .45-
30MHZ.
• This device is not intended for use with emergency exits or not for emergency lighting.
• Ensure lamp is kept away from flame or other high temperature objects.
• If lamp does not light when then luminaire is energized, remove lamp from the luminaire and contact the lamp
manufacturer or qualified electrician.
• If the lamp or the luminaire exhibits undesirable operation (buzzing, flickering, etc.), immediately turn off the
power, remove the lamp from the luminaire and contact the manufacturer or qualified electrician.
• Ambient temperature range under normal operation not to exceed -4°F to 113°F (-20°C to 45°C).
• Wiring must be in accordance with the National Electrical Code and all applicable local electrical safety
regulations.
• The lamps are intended to retrofit surface mount or recessed mounted fluorescent luminaries. The minimum
lamp compartment dimensions are in the table below with a maximum of 4 lamps:
service. solutions. simplicity.
eiko.com
T8 Type A
1