ALPATEC BH 2000 Mode D'emploi page 12

overheating.
- When the appliance switches itself on and off repeatedly, for reasons
other than the thermostat control, check to ensure that there are no obsta-
cles that impede correct air entry or expulsion.
Cleaning
- Disconnect the appliance from the mains and allow it to cool before
undertaking any cleaning task.
- Clean the equipment with a damp cloth with a few drops of washing-up
liquid and then dry.
- Do not use solvents, or products with an acid or base pH such as bleach,
or abrasive products, for cleaning the appliance.
- Never submerge the appliance in water or any other liquid or place it
under running water.
- If the appliance is not in good condition of cleanliness, its surface may
degrade and inexorably affect the duration of the appliance's useful life and
could become unsafe to use.
- Remark: When the appliance is used as a heater after long periods in
storage or after having been used solely as a fan a small amount of smoke
may be produced. This is not important and is due to the heater burning
dust deposits which have accumulated on the heating element. This pheno-
menon may be avoided by cleaning the inside of the appliance beforehand
through the grill with a vacuum cleaner or pressurised air.
Anomalies and repair
- Take the appliance to an authorised technical support service if problems
arise. Do not try to dismantle or repair without assistance, as this may be
dangerous.
For EU product versions and/or in the case that it is requested in your
country:
Ecology and recyclability of the product
- The materials of which the packaging of this appliance consists are
included in a collection, classification and recycling system. Should you
wish to dispose of them, use the appropriate public containers for each
type of material.
- The product does not contain concentrations of substances that could be
considered harmful to the environment
This symbol means that in case you wish to dispose of the
product once its working life has ended, take it to an
authorised waste agent for the selective collection of waste
electrical and electronic equipment (WEEE)
- This symbol means that surface could to get hot during the use
This appliance complies with Directive 2006/95/EC on Low Voltage and
Directive 2004/108/EC on Electromagnetic Compatibility.