Publicité
Les langues disponibles
Les langues disponibles
USING THE BLENDING VESSEL
IMPORTANT: Review all warnings at the beginning of this Owner's Guide before proceeding.
1
Ensure the motor base is fully charged and the vessel is properly installed
by aligning vessel arrow with motor base arrow located on the back of the
motor base.
5
Open the sip lid to sip, or remove the lid to pour out blender outputs
into another container. DO NOT remove vessel from motor base when
filled. Empty vessel prior to removing from motor base.
6
After blending, power OFF the unit by pressing the
Motor base should be turned OFF when drinking from the sip lid
and when blender is no longer in use.
7
Refer to the Care & Maintenance section for cleaning and
storage instructions.
INSTALLING VESSEL CAP AND BLADE COVER
After blending is complete, ensure the lid is on tight and turn the blender upside down. Twist anti
clockwise to remove the motor base from the vessel. Install the flat lid on the bottom of the vessel
and turn clockwise.
Install the blade cover on the motor base to cover the exposed blades by twisting anti clockwise.
ninjakitchen.eu
2
Turn unit ON by pressing the
lights illuminate.
3
Add ingredients, starting with liquids then solid ingredients. If using ice,
always add last. DO NOT fill ingredients past the MAX FILL line. Secure
lid onto the vessel, twisting clockwise to tighten.
4
Blend for a 30-second blend cycle by pressing the Start/Stop button.
button.
button until Start/Stop button
Publicité
