Kicker CompC Serie Manuel D'utilisation page 5

Installation
Wiring Configuration
CompC-Series subwoofers are made
with single and dual 4Ω voice coils. Voice
coils must be connected to a source of
amplification. The dual voice coil models
will provide a 2Ω load wired in parallel or
8Ω load wired in series. Make sure your
source unit or amplifier is rated at the
correct ohm load for operation.
The speaker wire should be kept away
from sharp edges and avoid the possibility
of getting pinched by the trunk. If a factory
hole and grommet do not exist or are
inaccessible, you must drill a hole through
which to run the wire. Be careful not to drill
into other wiring or existing mechanisms.
Any time a wire is run through a hole, it
is necessary to insert a rubber or plastic
grommet to protect the wire from damage.
English 5