7.9 Battery Replacement; Cleaning And Storage; Maintenance; Warranty - Greenlee GT50-NE Mode D'emploi

7.9 Battery Replacement

Remove the probes from any testing point, when opening the
battery case. Batteries are dead when the continuity test with
both test probes connected cannot be done anymore.
Follow the procedure below and replace batteries with new ones
(type IEC LR03 1.5 V).
• Unscrew the battery door
• Pull out the battery door and replace the batteries
• Insert new batteries according to the printing on the battery
door
• Re-assemble battery door.
• Confirm that the battery door case is properly locked prior to
measurements
8

Cleaning and storage

Tester does not need any special maintenance if used according
to user manual.
Remove tester from all test points before cleaning.
Use a lightly damp cloth with neutral detergent for cleaning the
instrument. Do not use abrasives or solvents.
Do not expose the instrument to direct sun light, high tempera-
ture and humidity or dewfall.
Remove batteries when the instrument will not be in use for a
long period.
9

Maintenance

• Unauthorized persons shall not disassemble the tester and the
supplementary equipment
• When using testers in compliance with the instruction manu al,
no particular maintenance is required
• If functional errors occur during normal operating, our service
department will check your instrument without delay
10

Warranty

The Instrument is subject to strict quality control. However, should the
instrument function improperly during normal use, you are protected
by our two years warranty.
We will repair or replace free of charge any defects in workmanship
material, provided the instrument is returned unopened and
unhampered with.
Damage due to dropping or incorrect handling is not covered by the
warranty.
If the instrument shows failure following expiry of warranty, our
service department can offer you a quick and economical repair.
18