Publicité
Les langues disponibles
Les langues disponibles
TRANSLATION OF ORIGINAL INSTRUCTIONS
This text has been carefully checked. Should any printing
errors be noted, these should be communicated to the
manufacturer.
With the aim of improving the product, we reserve the right
to update this publication without notice.
This booklet may not be reproduced in any form without
the manufacturer's authorisation.
The most important instructions are marked with the
symbol:
FOREWORD
This publication must be read before setting up, starting and
using the equipment. It is an integral part of the product itself.
Read the warnings and instructions contained in this booklet
carefully. They provide important information on the safe use
and maintenance of the equipment. Pay particular attention to
general safety instructions.
Keep this booklet in a safe place for future consultation.
These equipment are constructed according to current safety
standards and regulations.
The contents of this booklet should be brought to the attention
of the user.
CLASSIFICATION
The user of this appliance must respect the specified operating
conditions with particular regard to the following classification:
This appliance equipped with electric motor is classified as a
class I appliance in terms of protection against electric shock.
The equipment is adjusted in the factory and all safety de-
vices are sealed. Their adjustment must on no account
be altered.
The equipment must always be used on solid flat ground.
Failure to comply with this could constitute a source of dan-
ger.
The equipment must not be used in corrosive or potentially
explosive atmospheres (vapours or gas).
Electrical connections must be carried out in respect of cur-
rent legislation
(in compliance with the provisions of the IEC
60364-1
standard) and in accordance with the manufacturer's
instructions.
Check that the installation and sockets are adequate for the
maximum power of the appliance indicated on the rating plate
(W).
If in doubt, consult a qualified electrician.
The correct plug should be fitted by a qualified electrician.
The manufacturer declines all liability for damage to persons,
!
!
English
animals or things caused by faulty or incorrect connection.
Before connecting the equipment, check that the specifica-
tion given on the rating plate corresponds to that of the mains
electricity supply.
WARNING: If the equipment is connected via an extension, use
cables with an adequate cross section, never less than 1,5 mmq.
The electrical safety of the equipment is guaranteed only when
correctly and efficiently earthed as specified in current electrical
safety legislation
60364-1
standard).
This fundamental safety requisite should be verified. If in doubt,
ask a professionally qualified electrician to check the system
thoroughly.
The manufacturer declines all liability for damage caused by
faulty earthing of the appliance.
The equipment can be disconnected from the mains only by
unplugging the plug from the mains socket.
The equipment is intended solely for the production of pure
water used for cleaning solar/photovoltaic panels, windows,
vehicles, and washable surfaces typically through standard
and optional accessories provided by the manufacturer. The
water produced CANNOT be used for human consumption. Do
not use 'equipment in case of rain, snow, etc.. Any other use is
considered improper and unreasonable.
Examples of improper and/or incorrect use:
− Using the equipment in the rain, frost or strong winds.
− Clean surfaces not suitable for treatment with pure water.
− Using the appliance to clean animals, people, etc.
− Changing attachments while pure water is being emitted.
− Moving the appliance by pulling the electric cable.
− Using the appliance with a damaged electric cable.
− Cleaning the appliance with water jets.
− Cleaning the appliance when plugged into the mains.
− Using the appliance with wet hands and/or feet.
− Leaving the appliance unsupervised while running.
− Using the appliance without the guards (panels, grills).
− Obstructing ventilation and heat dispersal apertures or slits.
Use only original accessories offering maximum quality and
security. Failure to use original accessories absolves the manu-
facturer from all liability.
- 14 -
!
(in compliance with the provisions of the IEC
APPLICATIONS
Publicité
