PEERLESS SA752PU Installation Et Assemblage page 8

For Flat Back Screen
2-1
Begin with the shortest length screw, hand thread screw through multi-washer and screen brackets (B) into screen
as shown below. Screw must make at least three full turns into the mounting hole and fi t snug into place. Do not
over tighten. If screw cannot make three full turns into the screen, select a longer length screw from the baffl ed
fastener pack. Repeat for remaining mounting holes, level screen brackets and tighten screws.
NOTE: Spacers may not be used, depending upon the type of screen.
If you have any questions, please call Peerless customer care at 1-800-865-2112.
For Bump-out or Recessed Back Screen
Begin with longer length screw, hand thread screw through multi-washer, screen brackets (B) and spacer in that
2-2
order into screen as shown below. Screw must make at least three full turns into the mounting hole and fi t snug
into place. Do not over tighten. If screw cannot make three full turns into the screen, select a longer length screw
from the baffl ed fastener pack. Repeat for remaining mounting holes, level screen brackets and tighten screws.
If you have any questions, please call Peerless customer care at 1-800-865-2112.
All manuals and user guides at all-guides.com
SCREEN
B
SCREEN
SPACER
B
8 of 46
MULTI-WASHER
SCREW
MULTI-WASHER
SCREW
ISSUED: 10-30-09 SHEET #: 095-9297-2 12-04-09