Publicité
Les langues disponibles
Les langues disponibles
SETUP
Note:
Please fully charge the battery before using for the first time.
See "Charging the Headphones" on Page 10 for details.
TURNING THE HEADPHONES ON/OFF (BLUETOOTH MODE)
To turn the Headphones ON simply hold down the Power Button on the
left ear cup for 5 seconds. The status LED Indicator on the earcup will
flash three times, and you will hear a "Power On" voice through the
Headphones. Repeat this process to turn the Headphones OFF (and you
will hear a "Power Off" voice through the Headphones.)
Please note:
To conserve power, if the headset is not connected to a device
for approximately 10 minutes, the headset will turn off automatically.
To reactivate the Headphone just push the Power button.
The set up of this product varies depending on the device you are
using it with. Please locate the relevant section in the next few
pages before continuing with product set up.
CONNECTING DEVICES WITH BLUETOOTH®
1] Turn the Headphones ON by holding down the power button on the
left earcup for 5 seconds. If no previously paired devices are found
the headset will enter pairing mode immediately and say "pairing".
Pairing mode is indicated by the Status LED on the earcups flashing
blue. The headphones are now ready to connect to the device.
2] Go to the Bluetooth® option in the settings of your Bluetooth
Audio device or Smartphone and select 'FL400' in the list of devices.
You will hear a voice say "connected". The headphones are now
ready to use.
On future use, the headphones should pair automatically
within 10 seconds.
5
All manuals and user guides at all-guides.com
CONNECTING PLAYSTATION®4/3, PC, MAC
1] Plug the USB Dongle into a USB port on the device you want to connect.
2] Turn the Headphones ON by holding down the power button on the
Right Earcup for 5 seconds.
3] The headphones will automatically pair with the USB Dongle.
For specific setup instructions for your chosen device please refer to
the instructions below:
PS4
• PS4 > Settings > Devices > Audio Devices > Output to headphones >
Select 'All Audio'.
• Input and Output Device should be set to 'Gioteck FL400.'
• Adjust Mic sensitivity and volume output settings to desired levels.
PS3
Settings > Accessory Settings > Audio Device Settings > Choose the
'Gioteck FL400' as INPUT & OUTPUT.
PC
Sound > Start > Control Panel > Hardware and Sound > Manage Audio
Devices. On the Playback and Recording tabs select 'Gioteck FL400' as
default in the application you are using.
MAC
System Preferences > Sound. Set Input and Output 'Gioteck FL400'.
Then select 'Gioteck FL400' as default in the application you are using.
Please note:
When the FL400 is connected to the USB Dongle
Volume Up, Volume Down and Mute functions are operated with
the controls on the RIGHT EARCUP.
6
Publicité
