PULUZ PU360 Mode D'emploi page 4

A.Connection
12
09
B. Installation
01
02
03
05
06
07
Photo 1
10
1. With a 1/4 universal screw (06), mount the angle adjustment B (05) on the
horizontal base (07) and pull out the support leg (10) as Photo 2.
2. Put the phone on the gap between rubber mat A and rubber mat B, then
clamp the phone by rotating the knob (01) in the directionof T "+" (Photo 2).
Loosen it in opposite direction.
3. Tilt the phone in P"+" or "-" direction to adjust the angle of photographing
(Photo 3)
4. It is suitable for GoPro (as Photo 4) / DSLR (as Photo 5).
C. Indicator Light
Indicator light flashes in green continuously, waiting to connect Bluetooth;
When connected successfully, shines in green. When receiving remote
controller's command, flashes in blue; When charging, in red light; Fully
charged, red light off.
All manuals and user guides at all-guides.com
Instruction
+
P
+
-
T
-
Photo 2 Photo 3
03
1. Switch on by pressing (12), the
indicator light (09) will flash continuously
in green. Then open bluetooth in your
phone, find "PULUZ 360"and connect it.
Accordingly the indicator light (09) will
shine in green all the time.
Photo 4 Photo 5