Publicité
Les langues disponibles
Les langues disponibles
Assembly manual for Hand pump HPOl
This manual has been written to guide you in the assembly of the Mh2o hand pump
type HP0l, suitable for sucking water from a borehole or water storage. Manuals for
other Mh2o products can be found at www.mh2opompen.nl
Preparation:
In this installation manual we assume that
the location of the pump is already fully
equipped to be able to install the pump.
In brief:
• The supplied base plate and associated
threaded rods have already been poured
level in a concrete foundation, or you have
made all preparations for another proper
fastening.
• The threaded ends are shortened to 25mm
for the outermost and 16mm for the middle
above the base plate.
• A borehole is provided at depth with
sufficient supply or a water storage, of which the casing / supply is in the middle of the
base plate and of which the diameter does not exceed 110mm. This should be
shortened along with the base plate.
• Sufficient drainage options are provided for excess pumped-up or spilled water.
Required tools:
•
Two spanners 17mm
•
Allen key 8mm, 2.5mm and 1.5mm
•
Large slotted screwdriver
•
Pipe wrench
•
Drill with a 3mm drill bit
•
A clinker or paving stone
•
A piece of rope of at least 2 meters,
connect the sisal strings of the
packaging for this. Make a loop on one
side and tie a piece of cardboard from
the wrapping on the other side as a
bobbin.
Remarks:
• Installation of the HP01 hand pump requires two people.
• The heaviest part of the pump, the chassis weighs 14kg.
Assembly manual for Hand pump HPOl
0
BOER
PLAY
1 of 4
Publicité
