MASCO Bath Aqua Glass ASB Eleganza 48 Instructions D'installation page 6

WaLL sEt INstaLLatIoN (Continued)
9. Mark Panel Height
Top flange
◘
Check that vertical side panel flanges are straight and
square to base.
◘
Using a pencil, mark panel height on all wall studs.
11. Secure Back Panel
Top flange
1-1/4" screws
(panhead or roundhead)
◘
Press back panel in place.
IMPORTANT! Gaps between fl anges and studs must be
less than 1/8". Insert shims to fi ll gaps.
◘
Secure top flanges to studs with 1-1/4" screws.
 CAUTION:
Use panhead or roundhead screws. Do not
overtighten screws, this can cause panel to crack.
All manuals and user guides at all-guides.com
Top flange
Side
flange
Less than
Shim
1/8" gap
10. Apply Adhesive and Sealant
Back panel
support
◘
Remove and disassemble panels.

TIP: Pressure may be required to disengage hooks from
slots.
 APPLY ADHESIVE to back panel support.
 APPLY SEALANT along back of base.
12. Apply Adhesive and Sealant
 APPLY SEALANT along side of base and back panel as
shown.
 APPLY ADHESIVE to studs.
6
Pencil line
P/N 27740 10/11