Uzin Utz Wolff Groover Traduction Du Mode D'emploi Original page 5

EN Translation of the original instruction
Wolff Groover
It is essential to read through and retain the following before commissioning
1.0 Description of the device
1.1 Device description
The Wolff Groover is exclusively designed to eject a
groove for the incorporation of welding or fusion wire, at
the seam edges of vinyl, linoleum, PUR or rubber, in dry
rooms.
Der Wolff Groover is very eff ective for planing
vinyl safety fl ooring very eff ectively usable.
1.2 Important components Figure A
(1) Wolff Groover
(2) Shock knife
(3) Knurled screw
(4) Guide plate
(5) Allen key
2.0 Adjustment of the groove depth
 Loosen knurled screw (3) and remove planer (2).
 Set the set screw behind it to the desired cutting
depth using the Allen key (5).
 Insert plane (2) (groove direction up) and tighten
knurled screw (3).
 Check groove depth on a test piece.
 Groove depth can be infi nitely adjusted on both
sides.
The grub screw serves as a stop for the plane
so that it cannot move during work.
3.0 Application picture B
3.1 Planing
Guide the planer with uniform pressure
precisely along the butt joint.
Guided cut (1)
Working close to the wall (2)
Scope of delivery:
Wolff Groover
2 Hobel
Inbusschlüssel
Bedienungsanleitung
EN
5