Télécharger Imprimer la page

Presto 60359 Notice D'installation page 3

Seche mains automatique

Publicité

Les langues disponibles
  • FR

Les langues disponibles

  • FRANÇAIS, page 1
ENGLISH
1) INSTALLATION INSTRUCTIONS
2) PRESTO HEALTH – AUTOMATIC HAND-DRYER Part no. 60359 / 60360
3) Operation:
-Instantaneous activation after placing hands under the air terminal device.
-Automatic shut-off as soon as the hands are removed
-Anti shut-off safety: Automatic shut-off after 1 min of continuous detection.
Characteristics:
-Power 2300 W
-Weight = 4,5 Kg
-Supply voltage = 230VAC – 50 Hz
-Insulation class II
-Motor 2500 rpm
-Air speed = 22 m/s
-Flow: 210 m3/h
-Detection distance = from 50 to 200 mm
- Automatic shut-off after 1 min of continuous operation.
-Sound level < 78 dB
-Selector switch situated on the rear face used to lock the heating.
-Delivered with screws + dowel pins.
4) Installation instructions:
-The electrical connection must be carried out by authorised personnel.
-The exhaust opening must be situated at approximately 1.3 metres from the ground.
-No obstacle must be situated at less than 30cm from the base of the device.
-The hand-dryer must be connected to a protected line of minimum 16 amperes rating.
-In case of use in a bathroom, the hand-dryer must be beyond the reach of a person using a bath
tub, or a shower, (outside the safety volume 2).
- Disconnect the electrical receptacle of the hand-dryer before any intervention inside the hand-
dryer.
Installation instructions:
-Remove the front face after having removed the 2 screws located under the front face.
-Separate the front face from the frame.
-Apply the plumb frame on the partition according to the installation instructions, then point using a
marker the position of 4 mounting holes of pins.
-Drill the 4 holes Ø8, then fix the pins.
-Install the frame, then the front face in the reverse order to that of removal.
-Connect the power connector.
Thermal safety:
-In case of plugging of the air flow the thermal safety stops the hand-dryer.
-It gets rearmed after the fault disappears.
Maintenance:
-Disconnect the plug of the hand-dryer in case of prolonged disuse.
-Disconnect the hand-dryer plug to clean the front face (clean with a slightly damp cloth).
5) This document is not contractual, we reserve the right to modify the characteristics of our
products without notice.
6) PATENTED and REGISTERED MODELS

Publicité

loading

Ce manuel est également adapté pour:

60360