Aurora SDN118 Manuel Du Propriétaire page 7

OPERATING INSTRUCTIONS
DRY PICK-UP DRY PICK-UP
NOTE: If foam filter is in position over filter cage, it must be removed before installing cartridge filter.
The cartridge filter can be used for wet or dry pick up; installation is the same for both. When picking
up large quantities of liquid please refer to the Wet Pick UP Operation section in this manual. Use
the cartridge filter in position over the filter cage for most general dry material pick.
1. With the power head in an upside down postition, slide the cartridge filter down over the filter cage,
push the filter seals against the power head.
2. Place filter retainer into the top of the cartridge filter, hold the power head with one hand, turn the
handle on the filter retainer clockwise to tighten, locking the filter into place.
3. To remove the cartridge filter for cleaning, again hold the power head and turn the filter retainer
counter-clockwise to loosen and remove, slide the cartridge filter off the filter cage.
4. To clean the cartridge filter shake or brush off excess dirt or rinse(from the inside of the filter) with
water, dry completely (approximately 24 hours) and re-install.
NOTE: If the filter has been used for wet pick up, it must b cleaned and dried before using for
dry pick up.
5. Slide collar of filter bag into retainer guides.
6. When secured in place, expand bag and position around the inside of the tank.
7. This wet/dry vac is equipped with a dust-full indicator(Part 3) which will be lighted when the tank
is filled with dust or the filter is clogged with dust. When this hanppens, turn off vac, unplug the
power cord, and empty the dust tank or clean the filters.
NOTE:The dust-full indicator might be lighted when the wet/dry vac is used for wet pickup. No
action required.
All manuals and user guides at all-guides.com
Lock
Unlock
7
3