Kobe Range Hoods PREMIUM Série Manuel D'installation Et Mode D'emploi page 9

Preparation Before Installation
NOTE: TO AVOID DAMAGE TO YOUR HOOD, PREVENT DEBRIS
FROM ENTERING THE VENT OPENING.

Decide the location of the venting pipe from the hood to the
outside. Refer to Figure 1.

A straight, short vent run will allow the hood to perform more
efficiently.

Try to avoid as many transitions, elbows, and long run as
possible. This may reduce the performance of the hood.

Temporarily wire the hood to test for proper operation before
installing.

Important: Peel protective film off the hood, if any.

Use duct tape to seal joints between pipe sections.
CAUTION
: If moving the cooking range is necessary to
install the hood, turn off the power in an electric range at
the main electrical box. SHUT OFF THE GAS BEFORE
MOVING A GAS RANGE. And use a protective covering
to protect cooktop and/or countertop from damage.
Custom Hood Preparation
1. The custom hood frame must be designed based on the
shape and the weight of the hood. Refer to Measurements
and Diagrams of hood on Page 13-15.
2. A sturdy base (3/4 inch thick plywood recommended) is
needed to sustain the weight of hood.
3. It is recommended to install front & rear stud support (not
included). Refer to Figure 2.
installation holes on the side of the hood are provided.
Prepare the side stud support if needed.
4. Determine and mark the centerlines on the base of the wood
frame where the hood will be installed.
5. Determine the proper location for the Power Supply Cable.
Make a wiring access hole using a drill bit.
cable and seal the gap around hole.
6. Cut out the opening where the hood will be installed. (Refer to
Figure 3 for appropriate dimensions based on width of hood.)
Wiring to Power Supply
CAUTION
: If moving the cooking range is necessary to
install the hood, turn off the power in an electric range at
the main electrical box. SHUT OFF THE GAS BEFORE
MOVING A GAS RANGE. RISK OF ELECTRICAL SHOCK.
THIS RANGE HOOD MUST BE PROPERLY GROUNDED.
MAKE SURE THIS IS DONE BY QUALIFIED ELECTRICIAN
IN ACCORDANCE WITH ALL APPLICABLE NATIONAL
AND LOCAL
CONNECTING WIRES, SWITCH POWER OFF AT SERVICE
PANEL AND LOCK SERVICE PANEL TO PREVENT
POWER FROM BEING SWITCHED ON ACCIDENTALLY.
7. Temporarily wire the hood to test for proper operation before
installing. If the hood does not operate, check the circuit
breaker or house fuse. If the hood is still not working,
disconnect power supply and check the continuity of all wire
connections.
8. If hood is operating normally, connet three wires (black, white
For safety purposes, extra
ELECTRICAL CODES.
Figure 1
Figure 2
Figure 3
Install the wire
IN2636SQB-1200 (36")
IN2642SQB-1200 (42")
BEFORE
IN2648SQB-1200 (48")
5