Omnitech 15331 Manuel D'instructions page 4

Setting the Codes on Your Controller
To associate this controller with the devices that you have, you will need to refer to the lists of device
types listed at the end of this manual. You will need to identify and input the correct device code for
your unit as follows:
1. Turn on the device that you want to set.
2. Look for the brand name under the specific device listing provided.
(Note: You will notice that some brands will have more than one 3-digit code. During the code input
process, you may have to try more than one 3-digit code that will match your device brand and model.)
3. Aim the remote control at the device and press down and hold CODE SEARCH button for at least 3
seconds until the red LED lights up solid red.
4. Press the device button for the item you wish to program, e.g. TV, DVD, VCR, etc. and the LED light
will blink once and then remain solid red.
5. Using the number keys, enter the 1 st set of 3-digit codes from the list. You will notice that each
number that you press, the LED will blink once. After you have entered the 3rd digit, the red LED will
turn off indicating that the code was recognized for the device.
(NOTE: If the code entered was not compatible, the red LED will flash several times. You will then need
to repeat step 3. You have 30 seconds to enter a code.)
6. After the red LED light has turned off. Press the ON/OFF key. If the device you are trying to program
powers off, then you have found the correct code. If the device does not power off, then you will need
to repeat the process again from step 3, using another 3-digit code.
7.Make a note of the 3-digit code for future use.
Automatic Search
There is another way to set up your controller, that does not use the brand code lists. You can let your
controller search through all of its available codes automatically in order to set the connection to the
target device. To do this, follow these steps:
1.Turn on the target device.
2.Point the controller at the target device and press and hold the Code Search button for around 3
seconds, until the LED light stays red.
3.Next select the type of device the target unit is by using the Cable/TV/VCR/DVD/Sat Buttons (i.e. if
it is a TV that you are trying to control, press the TV button). The LED light should then blink once,
then stay red.
4.Press the On/Off button on the controller slowly and repeatedly until the device you are trying to
connect with turns off. (Note: the LED light will blink each time you press the On/Off button). When
this happens, press the ENTER button in order to store the code and the LED light will turn off.
Setting the Sleep Function
This feature allows you to set a time after which the controller will automatically turn off a target
device. To do this press and hold the Sleep button for around 3 seconds until the LED light turns on
and stays on.
Next, use the number keys to set the number of minutes after which you want the device to power off
– from 01-99 minutes. Press OK to confirm. The LED will turn off and the timer will begin. Ensure that
you leave the controller pointing at the target unit.
You can cancel this function by pressing the On/Off button or by pressing and holding the sleep button
for around 3 seconds, until the LED flashes once.
Displaying Stored Codes
Use this feature to find out which 3 digit code is associated with which of your devices.
All manuals and user guides at all-guides.com
3
Press and