NuTone LA522WH Instructions D'installation page 3

TROuBleshOOTing
The range of the door chime de-
pends on location, temperature and
battery condition. If you are having
problems with this product, please try
the solutions listed below.
chime rings on its own:
• Button frequency jumpers and
chime frequency jumpers
MUST BE SET TO THE SAME
FREqUENCY CODE. Change
the button frequency jumpers and
chime frequency jumpers to a dif-
ferent code.
BATTERY
Button Frequency Jumpers
(inside pushbutton case)
1 6
-
+
FReQuencY cOde
- SAMPLE SETTING -
Button Frequency Jumpers
(Jumpers removed (OFF) from 2, 4, 6)
chime Frequency Jumpers
(Jumpers removed (OFF) from 2, 4, 6)
PUSH
BUTTON
chime Fre-
quency
set Jumpers
Batteries are Ok, but chime does
not work when installed:
• Mounting the chime or button
directly on metal, concrete or near
metal studs reduces the range.
Use /4" to /2" wood shims to
move the chime or doorbell button
off of the surface.
• Do not mount the chime too close
to ground level concrete slabs
which may also reduce the range.
Mount the chime away from the
floor.
• Try different locations for the
chime closer to the button. Also,
try to orient the chime at a differ-
ent angle to increase the range.
Range is most effective to the
sides of the button.
chime doesn't sound:
• Make sure the button and the
chime are set to the same
frequency code.
• Replace the button battery. Also
check chime batteries.
Regulatory information
The user is cautioned that chang-
es or modifications not expressly
approved by the party respon-
sible for regulatory compliance
could void the user's authority to
operate this equipment.
This device complies with Part 5 of
the FCC rules.
This device complies with RSS-20
of the Industrial Canada Rule.
Operation is subject to the following
two conditions:
. This device may not cause harm-
ful interference, and
2. This device must accept any
interference received, including
interference that may cause unde-
sired operation.
3