Publicité
Les langues disponibles
Les langues disponibles
All manuals and user guides at all-guides.com
English
continuing successively in this manner until completing the 24 hours of day 1. The
hour strips go from 1 to 24h. The temperatures that can be selected go from 0 to 35ºC.
- Should you wish the same programming for several consecutive days, press
MODE once the configuration of the first 24 hours (day 1) has ended. In this way, each
time it is pressed the programming performed will be copied while advancing from day
to day.-
- Should you wish different programming for each day, repeat the steps explained
above (the table will automatically go on to day 2 once the 24 hours corresponding to
day 1 have ended, continuing successively in this way until the 168 hours of the week
are completed).
6. Start - Up and Operation.
Turn on the equipment by activating the hidden general switch located behind the
right-hand side electronic casing of the emitter. The lowest temperature (LO) of
programming mode P1 (15ºC) will appear the first time the equipment is turned on.
The following times, the lowest configured temperature in the selected programming
mode or the temperature selected in manual mode will appear. Once the equipment is
on, select the preferred operating mode as seen in section 5 (Operating Modes).
Setup Configuration.
Independently from the operating mode selected, you may access the operating
parameter configuration menu (SETUP), by pressing the MODE key for at least 5
seconds. This menu will allow you to set:
- Temperature unit type selection (ºC or ºF). Change from one mode to another by
pressing keys + and -. Temperature is in ºC by default. Press the MODE key to validate
the type of unit and go on to the following option.
- Fast detection probe calibration (Cal). All emitters are calibrated in the factory,
although it is possible that, in the odd case, the room temperature shown by the
apparatus does not (exactly) coincide with the real temperature. With this option you
may configure the temperature to be taken into account as room temperature (in ºC
the adjustment is performed in 0.1 steps and in ºF in 0.5 steps) using keys + and -.
Press the MODE key to validate this and go on to the following option.
- "High" operating temperature selection (HI). For programmes P1 to P9, select the
"high" temperature with the MODE key and validate using keys + and -. The default
temperature is set at 20ºC.
- "Low" operating temperature selection (LO). For programmes P1 to P9, select
the "low" temperature with the MODE key and validate using keys + and -. The default
temperature is set at validate the "low" temperature with the MODE key, using keys +
and - . This temperature is set at 15ºC.
- Selection of the type of LCD display lighting (Light). Using keys + and - allows
you to choose if you want the display to be lit permanently or for it to turn off after 20
seconds. 1 = always on/2 = off after 20''
- The keyboard lock option (Un Loc/Loc). If you select "Un Loc" the keyboard will be
unlocked, becoming locked if "Loc" is chosen, therefore not allowing any modification
to be made to the emitter. The keyboard will only be accessible by accessing SETUP
and selecting "Un Loc". The keyboard will be unlocked by default.
- Remote control type configuration. (IR) Infrared function. You may choose the
remote control you wish to use by means of keys + and -:
ACESOL
18
- Installation manual - Instructions for use
LCD
EN
Publicité
