Publicité
Les langues disponibles
Les langues disponibles
EN
7. Operation
7.1 Switching on/off
» Set the on/off switch (C) to I to switch the product on.
» Press the
button to activate/deactivate the AUTO and
manual shredding mode. The
goes off accordingly.
» Set the on/off switch (C) to O to switch the product off.
NOTICE
After 30 minutes of idle time, the product enters
sleeping mode.
7.2 Control panel
When in AUTO mode, the
AUTO
The motor runs only when paper/card or CD/DVD is
inserted into the feed slot, and stops automatically
when the material has passed through.
To exit AUTO mode, press
light goes off.
Press to urgently stop the shredding process and keep
REV
pressing to roll out the unshredded portion of paper/
card or CD/DVD.
Use the
button to clear jammed material.
FWD
Press the
button to manually start the shredding
process.
7.3 Shredding
The product runs briefly after each pass to clear entry.
Continuous operation beyond 20 minutes triggers a 20‑minute
cool down period.
7.3.1. Paper
NOTICE
» Always set the on/off switch (C) to O and unplug the
product when not in use.
» Do not exceed the sheet count per pass (max. 12 sheets of
80 g/m
paper). Insert paper as straight as possible into
2
paper/card feed slot (J) and release.
» One folded sheet of paper equates to 2 sheets of paper.
Heavier paper, humidity or a supply voltage lower than the
rated voltage may reduce shredding capacity.
» This product can shred staples and small paper clips.
Remove paper clips whenever possible to extend the
lifespan of the product.
4
button lights up blue or
button lights up blue.
button again. The blue
7.3.2. Credit card
NOTICE
» Only shred credit cards by feeding them vertically into
the middle of the paper/card feed slot (J), releasing when
shredding begins.
» The sensor is located in the middle of the paper/card feed
slot (J). Do not insert credit cards at the sides of the paper/
card feed slot (J).
» Never feed in more than one credit card at a time.
7.3.3. CD/DVD
C AUTION
Risk of injury!
» Do not hold CD/DVD with finger through the centre ring
while feeding into the CD/DVD feed slot (K).
NOTICE
» Never feed in more than one CD/DVD at a time.
» Hold a CD/DVD by its edge, feed in one at a time and release
when shredding begins.
Publicité
