Summit SCR 1300 Mode D'emploi page 4

● Never clean appliance parts with flammable fluids. These fumes can create a fire hazard
or explosion. And do not store or use gasoline or other flammable vapors and liquids in the
vicinity of this or any other appliance. The fumes can create a fire hazard or explosion.
● Before proceeding with cleaning and maintenance operations, make sure the power line of
the unit is disconnected.
● Do not connect or disconnect the electric plug when your hands are wet.
● Unplug the appliance or disconnect power before cleaning or servicing. Failure to do so can
result in electrical shock or death.
● Do not attempt to repair or replace any part of your appliance unless it is specifically re-
commended in this manual. All other servicing should be referred to a qualified technician.
FOLLOW WARNING CALLOUTS BELOW ONLY WHEN APPLICABLE TO YOUR MODEL
● Use two or more people to move and install appliance. Failure to do so can result in back or
other injury.
● To ensure proper ventilation for your appliance, the front of the unit must be completely
unobstructed. Choose a well-ventilated area with temperatures above 60°F (16°C) and
below 90°F (32°C). This unit must be installed in an area protected from the elements, such
as wind, rain, water spray or drips.
● The appliance should not be located next to ovens, grills or other sources of high heat.
● The appliance must be installed with all electrical, water and drain connections in accordan-
ce with state and local codes. A standard electrical supply (115 V AC only, 60 Hz), properly
grounded in accordance with the National Electrical Code and local codes and ordinances,
is required.
● Do not place chemical substances (solvents, reagents) in this refrigerator
● Do not kink or pinch the power supply cord of the appliance.
● The size of the fuse (or circuit breaker) should be 15 amperes.
● It is important that the appliance be leveled in order to work properly. You may need to
make several adjustments to level it.
● All installations must be in accordance with local plumbing code requirements.
● Make certain that the pipes are not pinched, kinked or damaged during installation.
● Check for leaks after connection.
4