Publicité
903908 - 12-31-01.qxd
2/13/02
CLEAN AND INSPECT DAILY
WARNING: Disconnect tool from air supply before cleaning and
inspection. Correct all problems before placing the tool back in use.
Wipe tool clean and inspect for wear or damage. Use non-flammable
cleaning solutions to wipe exterior of tool only if necessary. DO NOT SOAK
tool with cleaning solutions. Such solutions can damage internal parts.
Inspect trigger and safety mechanism to assure system is complete and
functional: no loose or missing parts, no binding or sticking parts.
Keep all screws tight. Loose screws can cause personal injury or damage
tool.
If tool is used without an in-line oiler: place 5 or 6 drops of Porter-Cable Air
Tool Oil into the air inlet of the tool at the beginning of each workday.
SERVICE AND REPAIRS
All quality tools will eventually require servicing or replacement of parts due
to wear from normal use. These operations, including brush inspection and
replacement, should ONLY be performed by either an AUTHORIZED
PORTER-CABLE SERVICE STATION or a PORTER-CABLE/DELTA
FACTORY SERVICE CENTER. All repairs made by these agencies are fully
guaranteed against defective material and workmanship. We cannot
guarantee repairs made or attempted by anyone other than these agencies.
Should you have any questions about your tool, feel free to write us at any
time. In any communications, please give all information shown on the
nameplate of your tool (model number, type, serial number, etc.).
WARNING: Disconnect tool from air supply before performing any
Service Procedure.
SYMPTOM
1. Air leak near top of
tool or in trigger area.
2. Tool does nothing or
operates sluggishly.
3. Air leak near bottom
of tool.
4. Tool jams frequently.
5. Other.
2:31 PM
Page 10
MAINTENANCE
TROUBLESHOOTING
PROBLEMS
SOLUTIONS
Loose screws.
Tighten screws.
Worn or damaged
Install Overhaul Kit.
o-rings or seals.
Inadequate air supply.
Verify adequate air supply.
Inadequate lubrication.
Put 5 or 6 drops of oil into air inlet.
Worn or damaged
Install Overhaul Kit.
o-rings or seals.
Loose screws.
Tighten screws.
Worn or damaged
Install Overhaul Kit.
o-rings or bumper.
Incorrect fasteners.
Verify approved fasteners of
correct size.
Damaged fasteners.
Replace w/undamaged fasteners.
Magazine or nose
Tighten screws.
screws loose.
Magazine is dirty.
Clean magazine.
Driver is worn or damaged.
Install "DRIVER" Maintenance Kit.
Contact a Porter-Cable
Service Facility.
10
Publicité
