R82 Gazelle PS Mode D'emploi page 18

Safety
Signs, symbols and instructions placed on this product must never be covered or removed and must
remain present and clearly legible throughout the entire lifetime of the product. Immediately replace or
repair illegible or damaged signs, symbols and instructions. Contact your local dealer for instructions.
Caregiver
• Read the "User Guide" carefully before use
EN
and keep it for future reference. Incorrect
use of this product may cause serious injury
to the user
• Always use the correct lifting techniques and
aids for this purpose
• Never leave the user unattended in this
product. Ensure permanent supervision by
an adult
• Repair/replacements must only be made
using new original R82 spare parts and
fittings and carried out in accordance
with the guidelines and service intervals
prescribed by the supplier
• If there is any doubt as to the continued
safe use of your R82 product or if any
parts should fail, stop using the product
immediately and contact your local dealer
as soon as possible
• Ensure that moving parts does not squeeze
or trap body parts when adjusting them
• Transportation of the product whilst the user
is in it is not allowed.
Environment
• Observe the surface temperature on the
product, before placing an user in it. This
goes especially for users with insensitive
skin as they cannot feel the heat. If the
surface temperature is above 41°C then
allow the product to cool before use
• Use this product on a level surface without
any obstacles. Be aware of reduced
maneuverability on slippery surfaces
• When using on inclines, please refer to
measurements
User
• If the user is close to the max. load limit
and/or has a lot of involuntary movements,
e.g. rocking, a larger size with a higher max.
load or a different R82 product should be
considered
All manuals and user guides at all-guides.com
Product
• Carry out all positional adjustments on the
• Activate the brakes before placing the user
• Ensure the stability of the product is
• Ensure the castors are fully-functional and
• Inspect the product and all of its accessories
• Do not expose the gas spring to pressure or
• Do not expose the piston rod to scratches
• The footplate is for support only! The foot
• This product is tested for resistance to
• The product might lose its flame resistant
• This product is not to be occupied in a motor
• The user must not occupy the product
Environmental conditions
• Operating temperature: 5°C to +40°C
• Storage temperature: -10°C to +50°C
• Relative humidity: 5% to 90%
• Atmospheric pressure: 800 to 1060 hPa
product and accessories and ensure that
all knobs, screws and buckles are securely
fastened before use. Keep all tools out of
the reach of children
into the product
maintained before placing the user in it
secure before use
and replace any worn out parts before use
high temperatures. DO NOT puncture
etc. It is important to use a cloth or the like,
if tools are used to adjust the gas spring
support does not have a weight bearing
function
ignition at level non-ignition in accordance
with EN 1021-1 and EN 1021-2
characteristics if using other than original
R82 cushioning
vehicle. The user must be positioned in a
vehicle seat and the product must be stored
in a luggage compartment
while it is being transported into or out of a
vehicle by a lift
18
support.R82.org