MaxPro MPPO1200/180VC Mode D'emploi page 8

All manuals and user guides at all-guides.com
P P olisher MPPO1200/180VC User Manual
2
B
F
E
G
D
C
A
L
3 Before using the tool
- ensure that accessory is correctly mounted and firmly tightened
- check if accessory runs freely by turning it by hand
- test-run tool for at least 30 seconds at highest no-load speed in a safe position
- stop immediately in case of considerable vibration or other defects and check tool to determine the cause
4 On/off
- switch on/off the tool by pulling/releasing trigger H
3
H
5 Electronic soft-start
Ensures reaching the maximum speed smoothly without a sudden impact when tool is switched on
6 Switch locking for continuous use
- pull trigger
- press knob J with your thumb
- unlock the switch by pulling again trigger H and then releasing it
4
J
H
GB 8