Beper BA.150 Manuel D'instructions page 9

Electric knife sharpener Use instructions
PRODUCT DESCRIPTIONS Fig.A
A. Base
B. On/off switch
C. Sharpening position 1 (2 blade guide slots)
D. Sharpening position 2 (2 blade guide slots)
USE INSTRUCTIONS
Moisten the bottom of the suction feet under the base (A) and then place the appliance on a stable surface.
Connect power plug to a suitable electric socket.
The sharpening wheels that are situated under the 2 sharpening positions (C & D) will start rotating when the
switch (B) is turned on.
Sharpening in 2 stages:
Stage 1: Precision sharpening
Place the knife's blade into the first blade guide slot of the sharpening position 1 (C) (Fig.1) holding it only by the
handle. Pay close attention and keep the fingers away from the cutting edge.
Slowly draw the knife towards the direction of the handle and repeat 3 times.
The knife's cutting edge should be kept parallel with the surface on which the appliance is placed (Fig.1), except
when sharpening the blade tip.
To sharpen the tip, lift up on the knife handle slightly as the curved portion of the blade is drawn through the
blade guide slot.
The duration of each pass in each slot depends on the blade's length. It is recommended 1 second for every 4
cm of blade's length, 2 seconds for 10 cm, and 3 seconds for 15 cm, etc.
Repeat the same process in the second blade guide slot, always in the same sharpening position 1 (C).
Stage 2: Fine sharpening and polishing
Repeat the same procedure of Stage 1 on the sharpening position 2 (D).
Complete this fine sharpening and polishing process with one quick pass of approximately one second in each
of the blade guide slot.
Turn off the switch (B) and unplug the appliance.
Clean the sharpened knife with a clean damp cloth before use.
CLEANING
Before cleaning the appliance make sure to turn it off and unplug it.
The appliance's body could be cleaned with a clean damp cloth. Do not clean it with detergents, abrasive pro-
ducts, which may damage it.
Eventual dust or metal filings could be removed by a small duster or a mini vacuum cleaner.
Do not allow water to penetrate the appliance.
Do not immerge the appliance in water or any other liquids.
TECHNICAL DATA
Power: 20W
Voltage: 220-240V ~ 50Hz
For any improvement reasons, Beper reserves the right to modify or improve the product without any
notice.
The European directive 2011/65/EU on Waste Electrical and Electronic Equipment (WEEE), requires
that old household electrical appliances must not be disposed of in the normal unsorted municipal
waste stream. Old appliances must be collected separately in order to optimize the recovery and
recycling of the materials they contain, and reduce the impact on human health and the environment.
The crossed out "wheeled bin" symbol on the product reminds you of your obligation, that when you
dispose of the appliance, it must be separately collected.
All manuals and user guides at all-guides.com
9
EN