DeFelsko PosiTest OTL Manuel D'instructions page 12

Troubleshooting and Returning for Service
Before returning your PosiTest OTL for service, first perform the
following actions:
1. Install new batteries in the proper alignment.
2. Examine each connected sensor and cable for debris or visible
damage.
3. Ensure that each K-type connector is not damaged.
If these steps do not resolve the issue and the PosiTest OTL
must be returned for service, please follow the instructions
provided at www.defelsko.com/service
Limited Warranty, Sole Remedy
Limited Warranty, Sole Remedy
DeFelsko's sole warranty, remedy, and liability are the express
limited warranty, remedy, and limited liability that are set forth on
its website: www.defelsko.com/terms
This manual is copyrighted with all rights reserved and may not be reproduced or transmitted, in whole
or part, by any means, without written permission from DeFelsko Corporation.
DeFelsko, PosiTector, PosiTest, and PosiSoft are trademarks of DeFelsko Corporation registered in the
U.S. and in other countries. Other brand or product names are trademarks or registered trademarks of
their respective holders.
Every effort has been made to ensure that the information in this manual is accurate. DeFelsko is not
responsible for printing or clerical errors.
and Limited Liability
and Limited Liability
www.defelsko.com
© DeFelsko Corporation USA 2022
All Rights Reserved