JMR AGAPE Mode D'emploi page 10

REAR PANEL
Connect physical sources.
Wi-Fi/Bluetooth antenna
1 2
RJ45 network input
3
Reset wifi network (press twice to connect to
4
or change network)
Analog input AUX Jack 3.5
5
Toslink digital input
6
USB B audio input from a computer (PC/Mac)
7
24V power supply
8
1
3 4 5
Control keyboard and access to the various
equalization settings (DSP)
STAND BY : Allows the system to be turned on
A
and put to sleep.
PREV : Allows to go to the previous song in a
B
playlist.
Leave pressed for 1.5 seconds until the «beep» is
heard, to return to the original «EQ Flat» preset of
the various DSP settings.
VOL - : Decrease the volume (press for fast des-
C
cent).
PLAY/PAUSE : Allows to play or pause the
D
playback.
2
6 7 8
C
VOL + : Increase the volume (press for fast in-
E
crease).
NEXT : Go to the next song of a playlist. Press
F
and hold for 1.5 seconds to go to the 3 other set-
tings proposed in sequence (press for 1.5 seconds
then «beep» then press again for 1.5 seconds to go to
the next one, etc).
Detail of the sequence of settings:
1. -2 dB below 200 Hz, for use on a shelf near a wall or
placed in the middle of a table
2. -4 dB below 200 Hz for use on a wall.
3. +3 dB above 2 kHz for outdoor use.
SOURCE : Allows to switch from one source
G
to another (streaming, aux in analog, digital in
TOSLINK, USB).
Press and hold for 1.5 seconds until you hear a
«beep» to activate or deactivate the D-Bass func-
tion (loudness).
10
A
B
D E
F
G