Grundig GDL 2661 X Mode D'emploi page 20

INSTALLATION OF THE APPLIANCE
The minimum distance between the
supporting surface for the cook-
ing equipment on the hob and the
lowest part of the range hood must
be not less than 50cm from elec-
tric cookers and 65cm from gas or
mixed cookers.
If the instructions for installation
for the gas hob specify a greater
distance, this must be adhered to.
Electrical connection
The mains power supply must cor-
respond to the rating indicated on
the plate situated inside the hood.
If provided with a plug connect the
hood to a socket in compliance with
current regulations and positioned
in an accessible area, after instal-
lation. If it not fitted with a plug
(direct mains connection) or if the
plug is not located in an accessible
area, after installation, apply a dou-
ble pole switch in accordance with
standards which assures the com-
plete disconnection of the mains
under conditions relating to over-
current category III, in accordance
with installation instructions.
Warning: Before re-connecting the
hood circuit to the mains supply
and checking the efficient function,
always check that the mains cable
is correctly assembled.
Warning: If the power cable is faulty,
it should be replaced by a qualified
person certified by the manufac-
turer, after sales service or similar
(preferably an electrician) or a per-
son described by importer.
20
Mounting
Before you start:
Check that the product purchased
7
has appropriate sizes for mount-
ing area.
Remove the charcoal (*) filter/s if
7
supplied (see also relative para-
graph). This/these is/are to be
mounted only if you want lo use
the hood in the filtering version.
Check (for transport reasons) that
7
there is no other supplied mate-
rial inside the hood (e.g. packets
with screws (*), guarantees (*),
etc.), eventually removing them
and keeping them.
If possible, disconnect and move
7
freestanding or slide-in range
from cabinet opening to provide
easier access to rear wall/ceiling.
Otherwise put a thick, protective
covering over countertop, cooktop
or range to protect from damage
and debris. Select a flat surface
for assembling the unit. Cover
that surface with a protective cov-
ering and place all canopy hood
parts and hardware in it.
In addition check whether near
7
the installation area of the hood
(in the area accessible also with
the hood mounted) an electric
socket is available and it is possi-
ble to connect a fumes discharge
device to the outside (only suction
version).