Mitsubishi Electric IT Extender PAC-WHS01IE-E Manuel D'installation page 5

3–1–2. Installing the IT Extender
indoor unit
1) Connect the cable from the connecting device (Wireless
Interface, USNAP Interface, or Equipment Controller)
to the Relay connector of the IT Extender.
2) Place the connected connector inside the lower case
and wind the cable (of USNAP Interface or Equipment
Controller) *¹ around the hooks in the lower case
that the unsheathed part of the cable stays inside the
lower and upper cases.
*1: Do not wind the cable of Wireless Interface.
3) Close and affix the upper case
2 screws .
4) Use the screws , ,
Cable from the connecting devices
(Wireless Interface, USNAP Interface,
or Equipment Controller)
Relay connector connection cable
Length: 590-9/16" (15,000)
Notes:
● Avoid routing cables around metal surface.
● Do not route cables near noise sources such as motors.
● Corporate Logo can be upside down depending on the
installation direction of IT Extender.
If you are eager to reverse it, remove the case of IT Extender
and attach it again in an inverted position.
Removing case of IT Extender
● Remove 2 screws from the back side of
IT Extender and remove the case.
Screw
Back side of
IT Extender
Screw
Screw
and lower case
to install to the wall.
Screw
Screw
Connecting
cable (5-wire)
,
Upper case
, so
with
Lower case
Screw
Caution
● Do not touch the cables inside the IT Extender.
● If the cables come off IT Extender, stow them as shown
in the photo on the below.
Screw
Mounting cord
clamp
Hook
Relay
connector
Hook
Screw
Screw
Indoor unit connection cable
Length: 64-31/32" (1,650)
Unit: inch (mm)
EN-4