Publicité
Les langues disponibles
Les langues disponibles
PRODUCT OVERVIEW
Handle
(at the rear of the fan heater)
Tip-over switch
(on the bottom of the fan heater)
46
Thermostat
Heat setting
knob
control knob
I Low heat
II High heat
Fan
0 OFF
OPERATION
The heater carries a symbol
'DO NOT COVER' to alert the user to the risk of
overheating that exists if the heater is accidentally covered.
When using your heater for the first time, it is normal for the heater to
emit a 'new heater' smell, which will disappear after a while.
Ensure good ventilation.
1. Place the heater on a flat, dry and clean floor. Do not to put appliance on a
rug or carpet.
•
Position the heater upright on the floor, at least 1 m away from the
wall, away from curtains, furniture or wall coverings.
2. Turn the thermostat knob to the minimum position, and then turn the heat
setting control knob to the '0' position.
3. Plug in the heater.
4. Turn the thermostat knob fully clockwise to the maximum position, and
then turn the heat setting control knob the desired heat setting.
•
The fan heater has four modes:
0
Turn off the fan heater.
For fan only operation with no output of heat
I
Set the fan heater to low heat mode (900W).
Set the fan heater to high heat mode (1800W).
II
Please also turn the thermostat knob to the 'MAX' position.
5. To set the temperature, turn the thermostat knob to the desired position.
•
The thermostat control can be used to maintain your desired room
temperature.
•
Once the room temperature feels comfortable, turn the thermostat
knob slowly towards the minimal position.
6. To turn the fan heater off, turn the heat setting control knob to the '0'
position, and turn the thermostat control knob to the minimum position.
Unplug the fan heater from the mains socket.
47
Publicité
