i. "0" is default setting – In this setting, ice is made about every 6-12 minutes depending on the size of the ice cube
selected and the temperature of the room.
ii. "1" will add 1 minute to standard ice-making cycle.
iii. "2" will add 2 minutes to the standard ice-making cycle.
c) The '0','1','2' setting will disappear and the setting has been programmed
Note: If the unit is powered off, the unit reset back to default setting. If the unit is turned off but power is still ON (on
standby mode), the setting will remain.
Changing the Length of Time Water is Dispensed
a) Press the "WATER" button for few seconds until "10" appears in the Timer setting / Delay time from display area of LCD
window.
b) Press "SELECT" button to choose the length of water dispensing time from range of 7 seconds to 25 seconds.
c) When the chosen time disappears from the display, the setting is saved.
Note: If the unit is powered off, it will reset back to default setting. If the unit is turned off but power is still ON (on
standby mode), the setting will remain.
When Ice Full indicator is on
The ice maker automatically stops working when the internal ice cube bin ice-cube is full, and the "
symbol on LCD display window will be indicated and the letter "F" will flash.
When Ice Full indicator is on
The "
" symbol will light on LCD display window and the arrow symbol will flash.Add water to the water reservoir
Press the "ON/OFF" button to turn off the unit first. Next fill water up to the MAX level mark. Finally press "ON/OFF"
button again to restart the unit.
How to drain out the water inside the unit
To clean the unit or change water, you should first drain the remaining
water from the water reservoir. Unplug the drain cap to empty the reservoir
It is recommended that you change water in water reservoir every 24 hours
to ensure the water used is fresh and clean. If the unit is not used for an
extended period of time, drain the water reservoir and wipe dry.
All manuals and user guides at all-guides.com
8
" ice full"