EHEIM pHcontrol+ 6062 Mode D'emploi page 27

English
Connecting to the WLAN network
2. Open the network settings of your terminal device (smartphone, tablet, notebook
etc.).
3. Connect the terminal device to the WLAN network (SSID)
EHEIM pHcontrol XXXXXXXX.
4. Enter the network security key.
You can find the security key of the network at the back of the pH controller. Alterna-
tively, you can also scan the QR code 1 (see label) to establish the connection for the
first time (⌦J).
Calling up the website
5. Open your web browser and enter the following address: http://192.168.1.1
Alternatively, you can also scan the QR code 2 (see label) to open the software in the
browser.
Initial configuration
6. Select the desired language from the language selection and follow the instruc-
tions for the initial configuration.
Meaning of the status LED
‧ The status LED flashes white: The network is being searched for or created
‧ The status LED illuminates blue: pH controller is in master mode
‧ The status LED illuminates green: pH controller is connected to another EHEIM digital unit
Resetting the pH controller
1. Press the touch field ⑩ with your finger for approx. 8 – 10 seconds until the
status LED ⑨ illuminates in alternating colours (⌦I).
‧ When the status LED illuminates green, the reset is complete. The pH controller
recreates the network.
‧ The network security key and QR code 1 are invalid. The network can be con-
nected to without the network security key.
27