Publicité
Les langues disponibles
Les langues disponibles
Warning!
Do not swap control boxes between desks. Please connect power cable only when desk is
fully assembled.
Power adapter only for use at your desk.
1.
After when the desk with electrical frame will be assembled, please press the button „-".
Please hold it up to that time when the worktop will reach the lowest position. After that
calibration - the desk will be ready to use.
2.
Pressing and holding the button "up arrow" "+" moves the desk to the top – similarly to
move down press the button "down arrow" „-".
3.
Continuously holding the button height of the driver can interrupt the adjustment, allowing
the motors to cool down and regarding to this there will be a display lighting with the
message "cooling time".
As soon as the motors are ready to go on, the controller again allows you to change the
height.
4.
The desk has anti-collision system, which in case of detecting sudden obstacles stops the
movement at the moment and takes away the desk to the opposite side around few
centimeters.
5.
If the desk height gets out of order, it should be recalibrated. Firstly, make sure that the
desk is connected to the power supply. Then disconnect the plug from any column from
the driver for 5 seconds and reconnect the plug. Afterwards, proceed as described under
point 1.
6.
In case of danger turn off the power.
MANUAL INSTRUCTION OF DESKS WITH ELECTRIC HEIGHT
ADJUSTMENT FOR THE FINAL USER
Publicité
