Probuilder 69350 Manuel D'instructions page 48

Main components - 69350
6
Main components - 69360
6
Main components - 69380s
6
48
All manuals and user guides at all-guidesbox.com
1
2
4
3
5
1
2
4
3
5
1
2
4
3
5
1. Handle
2. Compressed air nozzle
3. Trigger
4. Magazine release
5. Magazine
6. Safety release (not valid for 69360)
Use
Loading brad nails or staples
Check that the staple/nail gun is not
connected to the compressed air supply.
Press the magazine release (4) and open the
magazine (5).
Load the required staples or brad nails
into the magazine. The points must point
downwards and the brad nails or staples
should be pushed forward by the feeder.
Close the magazine. Check that it clicks into
place and cannot be pushed to one side
without pressing the release.
Adjusting the discharge depth
Connect the staple/nail gun to the air supply,
and be sure that the air pressure supply is
correct.
Use the air supply regulator (h) to adjust the
depth to which the brad nails or staples are
to be driven into the workpiece.
Check the discharge depth is correct on a
piece of scrap wood before using the staple/
nail gun on the item.