Outsunny 845-489V90 Manuel D'assemblage Et D'instructions page 8

Turn the machine over onto its head.
Insert the Axle through the pre-drilled holes in the foot (Fig.3).
Select the support A and B which are identified by the letter stamped on the actual
support.
Insert the foot into the body (Fig.4).
Foot A
Axle
Put the cotter pin in to the pipe hole
Tighten the reamer knob. The reamer knob has a safety switch please ensure the
knob is tightened or the motor will not activate.
Foot B
Fig.3
Reamer
knob
EN
Insert
Fig.4
Fig.6