Outsunny 845-489V90 Manuel D'assemblage Et D'instructions page 5

EN
Attention
The electrical AC MAINS SUPPLY may experience voltage drops when starting this
equipment. This can influence other equipment (e.g. blinking of a lights). If the AC
MAINS SUPPLY impedance Zmax is less than 0.40 0HM at 50Hz, such
disturbances are not expected. If necessary, you may contact your local supply
authority for further information.
Use outdoor extension leads
When this tool is used outdoors, use only extension cords intended for outdoor use.
Keep work area clean
Cluttered and untidy areas invite injuries.
Consider work area environment
Do not expose power tool to rain.
Do not use power tools in damp or wet conditions.
Keep work areas well lit.
Do not use power tools where there is a risk of causing fire or explosion.
Guard against electric shock
Avoid body contact with earthed or grounded surfaces, e.g. pipes, cables etc.
Keep children and pets away from the work area
Do not let visitors touch the tool or extension cord. All visitors should be kept away
from the work area.
Store idle tool
When not in use, tools should be stored in a dry, high or locked up place, out of
reach of children.
Use the right tool
Do not force power tools or attachments to do the job of a heavy duty tool. Do not
use this tool for a purpose for which it is not intended.
Dress properly
Do not wear loose clothing or jewelry, they can be caught in moving parts. Gloves
and non-slip footwear are recommended when working outdoors. Wear protective
hair covering to contain long hair.
Use protective equipment
Use safety glasses, face or dust mask if the cutting operation is dirty. When using
for extended periods, or when the noise level is high, use hearing protection.
Do not force the tool
It will do the job better and safer at the rate for which it was intended.
Secure tool
Use clamps or a vice to hold the tool, it is safer than using your hands and it frees
both hands to work on the tool.
Arrange cord
Ensure the cord is arranged so that it cannot be tripped over, stopped on or have
heavy weights rested on it and make sure that the cord will not be subjected to any
damage.