Hubbell PMOMP Serie Instructions D'installation

CCT & Power Select Guidance
Warning
1. Select desired CCT & Wattage before operation!
2. Cap must be screwed back after CCT & Power selection!
ON
CCT & Wattage
Select Modular
Wattage Select
ON ON
100% (Default)
Photocell
ON ON
Sensor OFF
Sensor ON
(Default)
CCT Select
ON ON
5000K 4000K(Default)
Page 4
Cap
ON
80% 60%
ON
3000K
LED Wall Pack Economy
Installa�on Instruc�ons
Warning
• Risk of Fire, Electrical Shock, Cuts or other Casualty Hazards- Installation and maintenance of this
product must be performed by a qualified electrician.
•This product must be installed in accordance with the applicable installation code by a person familiar
with the construction and operation of the product and hazards involved.
• Risk of Fire and Electric Shock- Make certain power is OFF before starting installation or attempting
any maintenance.
• Disconnect power at fuse or circuit breaker.
• Risk of Fire- Refer to product label for specific minimum supply conductor requirements.
• Risk of Personal Injury- Fixture may become damaged and/or unstable if not installed properly.
• Failure to comply with these instructions may result in death, serious bodily injury and property damage.
DISCLAIMER OF LIABILITY:
Manufacturer assumes no liability for damages or losses of any kind that
may arise from the improper, careless, or negligent installation, handling or use of this product.
NOTICE:
Green ground wire provided in proper location. Do not relocate.
SAFETY:
This fixture must be wired in accordance with the National Electrical Code and applicable local codes
and ordinances. Proper grounding is required to ensure personal safety. Carefully observe grounding
procedure under installation section.
APPLICATIONS:
This lighting fixture is designed for outdoor lighting services and should not be used in area of limited
ventilation or inside high ambient temperature enclosures where ambient temperature surrounding the
fixture exceed the ambient temperatures marked on the product.
STORAGE:
Store in a dry location prior to installation. Do not expose lighting fixture to rain, dust or other
environmental conditions prior to installation and insertion of photo control or shorting cap (if so equipped).
Best results will be obtained if installed and maintained according to the following recommendations.
Wiring Instructions
For dimming wires, use
class 1 wiring methods.
Cap dimming wires
(separately) if not used.
This high-quality product has been designed for use with a low voltage 0-10V dimmer.
DO NOT USE STANDARD WALL DIMMER
Page 1
-
Pink or Grey Wire