4. Connect the female end of the aluminum adapter to the
trigger gun. Then connect the high-pressure hose end
(14mm M22 threading) to the male end of the aluminum
adapter (Fig. 25).
Fig. 25
Aluminum
adapter
m
IMPORTANT!
Do not use a 14 mm M22 connection on
a 15 mm M22 connection or vice versa. Always use the correct
connectors with the correct fittings. Incorrect pairings may
lead to leakage or damage.
Storage
m
CAUTION!
Always store your pressure washer in a
location where the temperature will not fall below 32ºF (0ºC).
The pump in this machine is susceptible to permanent damage
if it freezes. FREEZE DAMAGE IS NOT COVERED BY THE
WARRANTY.
• Store the pressure washer indoors in a dry, covered area
where it is not subject to adverse weather conditions.
• It is important to store this product in a frost-free area.
• Always empty water from the hoses, the pump, and the
foamer cannon tank (if using) before storing.
m
CAUTION!
recommended to prevent cold weather damage during
storage over the winter months.
Winterizing + long-term storage
Trigger gun
If you must store your pressure washer in a location where
the temperature falls below 32ºF (0ºC), you can minimize the
chance of damage to your machine by utilizing the following
procedure:
• Disconnect all water connections.
• Turn on the pressure washer for a few seconds until the
remaining water in the pump exits. Turn off immediately.
• Do not allow the high-pressure hose to become kinked.
• Store the machine and accessories in a room that does
not reach freezing temperatures.
• Do not store near a furnace or other sources of heat that
may dry out the pump seals.
• Operate the pressure washer with non-corrosive/non-toxic
anti-freeze, a pump saver, or a pump protector before
storing for the winter.
m
WARNING!
unit out with clear water. Anti-freeze products can damage
paintwork, so you must ensure there is no anti-freeze left
in the system before using it again.
13
The use of a pump protector is
Before reusing, completely flush the