Koenic KVR 4120 Mode D'emploi page 19

Warning!
When the vacuum cleaner is left standing, it
must be switched off, because if the brush
is turning while the product is standing , it
could cause damage to the floor surface.
After vacuuming, press the On/Off button to
turn off the product.
Cleaning and care
Warning!
• When cleaning the product, never use
solvents or abrasive materials, hard
brushes, metallic or sharp objects.
Solvents are harmful to human health and
can attack plastic parts, while abrasive
cleaning mechanisms and tools may
scratch the surface(s).
• Never immerse any electrical parts of the
product in water or in other liquids during
cleaning. Never place it under running
water.
Emptying dust container and cleaning
filters
Note: The dust container should be emptied
every time after vacuuming.
To empty the dust container, press the
Fig.
10
dust container bottom release button
so that the bottom lid of the container
opens and the dust falls out. Hold the
dust container over a dustbin. If the
filter and dust container are relatively
clean, close the lid again so that it
snaps into place. The vacuum cleaner is
ready for use.
IM_KVR4120_180806_V06_HR.indb 19
All manuals and user guides at all-guides.com
For better cleaning, loosen the dust
Fig. 11
container and remove it. Remove the
complete filter element and the fine
filter. Empty the dust from the dust
container and tap the filters. The filter
element and dust container can also
be rinsed with water if completely
dried afterwards. When cleaning the
elements with water, make sure that
they are completely dry before re-
assembly.
Mount all previously removed
components. The assembly is done in
reverse order. When assembling make
sure that no seal is lost or crushed and
that no parts are jamming.
Regularly clean the exhaust air side
Fig.
12
paper filter (Hepa filter). Turn off the
cap and remove the paper filter. Tap
the paper filter thoroughly. Under
no circumstances should the paper
filter get wet. The assembly is done in
reverse order.
Cleaning floor nozzle
The floor nozzle should be cleaned at
Fig. 13
regular intervals. To clean it, release the
floor noozle from the handstick vacuum
cleaner. Push the clip to remove the
latch.
Take out the brush roller from the
nozzle. Cut through threads and hairs
wounded round the rollers using
scissors and remove them.
Note: If the wheels are blocked with threads
and hairs, use scissors to carefully remove
the blockage.
Re-assemble all of the components that have
previously been removed. Assembly is carried
out in reverse order.
English
19
6/8/18 2:38 pm