Oregon LM300 Manuel D'instructions page 20

All manuals and user guides at all-guides.com
TROUBLESHOOTING :
Problem Possible Cause
Area of cut (battery Height of cut too low
duration)not large
enough
Grass too high
Grass wet or damp
Grass is dense
Cutting blade not Cutting blade obstructed
rotating while
garden product
switched on
Blade nut/bolt loose
Excessive Blade nut/bolt loose
vibrations/noise
No charging Battery contacts contaminated
procedure possible
The battery is defective, due to
a disconnection in the battery
The charge Mains plug of battery charger
control LEDs and not plugged in (properly)
respectively, do
not light up after
Socket outlet, mains cable or
inserting the mains
battery charger defective
plug into the socket
20
Troubleshooting
Corrective Action
Increase height of cut and walk
slower
Increase height of cut and walk
slower
Wait until grass is dry and walk
slower
Increase height of cut, walk
slower and cut more frequently
Remove battery, remove safety
key
Clear obstruction (always wear
gardening gloves)
Remove battery, remove safety
key .
Tighten blade nut/bolt (15 Nm)
Remove battery, remove safety
key .
Tighten blade nut/bolt (15 Nm)
Clean the battery contacts (e .g .
by inserting and removing the
battery several times) or replace
the battery
Replace the battery
Insert mains plug (fully) into the
socket outlet
Check the mains voltage
and if necessary, have the
battery charger checked by an
authorized customer service
station for power tools
Oregon® Lawnmower Model LM300